<p>PM02D provides regulated power supply for your Pixhawk® 5X &amp; 6X from the battery, &nbsp;as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S (LV) or 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.</p><p><br></p><p>It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.</p><p><br></p><h4><b><br></b></h4><h4><b>Specification</b></h4><p><br></p><p>Input voltage&nbsp;</p><p>LV: 2S-6S</p><p>HV: 2S-12S</p><p>PCB Cont. Current Rating: 60A</p><p>PCB Burst Current Rating: 100A (&lt;60 Sec)</p><p>Max current sensing:</p><p>LV: 164A</p><p>HV: 327A</p><p>Voltage and current monitor with I2C compatible interface&nbsp;</p><p>Outputs 5.2V and 3A max&nbsp;</p><p>Weight: 20g</p><p><br></p><p><b>PX4 Parameter Setup:</b></p><p><br></p><p>If you are using the PM02D HV version, you must set SENS_EN_INA228 to enable.</p>