<p>The Cube, Kore is a new Carrier Board of ProfiCNC/HEX. The Cube, Kore integrates all the interfaces of the Standard Carrier Boards and is for use with the Pixhawk2.1 Cube, and future versions of the Cubes provided.</p><p><br></p><p>The construction of a Multicopter, and, of course, other vehicle types, to be facilitated by the use of the Cube Kore Carrier Boards is enormous. The integrated Power Distribution Board (power distribution) is already equipped with a current Sensor and a total of 50V and a max. approx. 140 a load.</p><p>Built-in Step-Down Module for 5V and 12V consumers (e.g., Gimbal, FPV Equipment and more, additional Payload) to simplify the wiring and reduce overall cable clutter.<br></p><p><br></p><p>In addition, each of the 4 welding pads for the ESC power supply, and pin strips for the Signal cables of the ESC's. The manufacturer has thought in these areas also on a 12V supply for the LED.</p><p><br></p><h4><span style="font-weight: bold;">Features:</span></h4><h4><span style="font-weight: bold;"><br></span></h4><ul><li>&nbsp;Up to 12-cell Lithium battery (50,4 V)<br></li><li></li><li>Can withstand up to 140A continuous current short-time load peaks of up to 280A</li><li>Connections for the power supply and the RC Signal for ESCs in the corners</li><li>12V navigation light power at each corner available, built-in power distribution</li><li>Built-in Sensor for voltage (V) and amperage (A)</li><li>Redundant Layout for flight critical components</li><li>Load plug - in connector with resettable Fuses for 5V, 12V and direct battery supply</li><li>LED indication for power OK or is a Problem/error</li><li>Built-in Buzzer with volume control</li><li>Connectors for each function of the Pixhawk2.1 The Cube</li><li>Easily accessible PWM voltage selection switch (3.3 V or 5 V)</li><li>Resistance to mass Bouncing to the PWM Signal</li><li>Connector compatible with Standard ProfiCNC Carrier Board</li><li>Connector Ports for debugging IO, and FMU</li></ul>