<h4><span style="font-size: 12px; line-height: 1.42857;">R12DS, 2.4G 12 channel receiver, DSSS and FHSS used for the item Radiolink AT9, AT9S, AT10, AT10II.</span></h4><h4><span style="line-height: 1.42857;"><span style="font-size: 12px;">SBUS and PWM signal possible working at the same time.</span><br></span></h4><p><span style="font-weight: bold;"><br></span></p><p><span style="font-weight: bold;">FEATURE:</span></p><p>1. DSSS &amp; FHSS technique, super anti-interference</p><p>2. RX voltage and signal strength telemetry, extensional sensor for EP, Temperature, RPM, GPS etc.</p><p>3. Sbus 12CH Output</p><p>4. All 12channel needs 3ms to response parallel</p><p>5. Section precision 4096, stable the servo, rudder shaking free.</p><p>6. HV input up to 10V</p><p>&nbsp;</p><h4><span style="font-weight: bold;">Two signal working mode:</span></h4><h4><span style="font-weight: bold;">&nbsp;</span></h4><p>(1)PWM signal output working mode：red LED indicates PWM signal output, 11 channels Totally.<br>(2) S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.<br>&nbsp;<br>S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).</p>