<p>PM06D provides regulated power supply for your Pixhawk® 5X &amp; 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.</p><p><br></p><p>The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.</p><h4><b><br></b></h4><h4><b>Specification</b></h4><p><br></p><p>Input voltage: 2S- 14S</p><p>PCB Cont. Current Rating: 70A</p><p>PCB Burst Current Rating: 120A (&lt;60 Sec)</p><p>Max current sensing: 327A</p><p>Voltage and current monitor with I2C compatible interface&nbsp;</p><p>Connector Outputs: 5.2V and 3A max&nbsp;</p><p><br></p>