<p>PM02 Power Module is a simple way of providing your autopilot flight controller with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from up to a 12S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.</p><p>The Power Module is designed to power autopilot flight controller, a RC receiver and APM accessories (GPS, radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.</p><p>The GH terminal is also compatible with Pix32,Pixhawk4,Pixhawk4 mini, Pix32v5 and Durandal.&nbsp;</p><p><br></p><p><b>Note: This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X (Requires a digital PM like PM02D).&nbsp;</b></p><p><b><br></b></p><p><b><br></b></p><p><b>Make the PM02 show the quantity of electric charge of your battery</b></p><p><br></p><p>Mission Planner setup:</p><p>Connect PM02 to the battery, also connect it to Mission Planner via USB.</p><p>Click “INITIAL SETUP” and come to the menu “Battery Monitor”.</p><p>Make “Monito” into “Analog Voltage and Current”.</p><p>Make “Sensor” into “9: Holybro Pixhawk4 PM”.</p><p>Make “HW Ver: "The Cube or Pixhawk" （pixhawk4,pixhawk4mini,pix32v5,pix32）”※ &nbsp;&nbsp;</p><p>&nbsp; &nbsp; &nbsp; &nbsp; “HW Ver: &nbsp;Durandal（Durandal）”※ &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;&nbsp;</p><p>Input “18.182” into Voltage divider (Calced).</p><p>Input “36.364” into “Amperes per volt”.</p><p></p><p>Disconnect and reconnect it to finish the setting up.（“Measured battery voltage” shows the current quantity of electric charge of the battery.）</p><p><br></p>