True
Product Image

RFD868-EU 868Mhz 500mW Telemetry Modules for Pixhawk

359.00 € 359.00 €

RFD868-EU 868Mhz 500mW Telemetry Modules for Pixhawk

Create a new review
3

359.00 € 359.00 € 359.0 EUR

296.69 €

(0% Off)
Ex. Tax: 296.69 € 296.6942148760331 EUR
Days
:
Hours
:
Mins
:
Secs
  • Accessories

This combination does not exist.

Add to Cart
SKU:
N/A
Brand:  Cubepilot RF001-EU
Cubepilot
RF001-EU
5 1 1

Share :
  •  True Stock of Products
  •    Fast & Free Shipping*
  •   Secure Payment
<p>Long range &gt;40km depending on antennas and GCS setup *80km demonstrated by Edge Research labs on a balloon !, 57km in India, on Dipoles.</p><p>2 x RP-SMA RF connectors, diversity switched.</p><p>500mWatt (+20dBm) transmit power.</p><p>Transmit low pass filter.</p><p>&gt; 20dB Low noise amplifier, high IP3.</p><p>RX SAW filter.</p><p>All I/O ESD protected and filtered.</p><p>Re implemented SiK and Multipoint SiK firmware, field upgradeable, easy to configure.</p><p>Small, light weight.</p><p>Note: Not compatible with older modems</p><h3><span style="font-weight: bold;"><br></span><span style="font-weight: bold;">Software / GCS Support:</span></h3><p>The software solution is an open source development called "SiK".&nbsp; It has been re implemented to suit the new processor architecture available on the 32bit ARM processor core.&nbsp; A boot loader and interface is available for further development and field upgrade of the modem firmware via the serial port. Most parameters are configurable via AT commands, Eg. baud rate (air/uart), frequency band, power levels. Integrated support for configuring the RFD900 radios is supported by APM Planner. The default settings are at 57600 baud, N, 8, 1, and 64k air data rate. The RFD868/900x manual is here: RFD900x Manual The RFD868/900x SiK software manual is here : RFD900x Peer-to-peer Manual </p><p><br></p><p><span style="font-weight: bold;">Software features include:</span></p><p><br></p><p></p><ul><li>Frequency hopping spread spectrum (FHSS)</li><li>Transparent serial link</li><li>Point to Point, or Multipoint networking</li><li>Configuration by simple AT commands for local radio, RT commands for remote radio</li><li>User configurable serial data rates and air datarates</li><li>Error correction routines, Mavlink protocol framing (user selectable)</li><li>Mavlink radio status reporting (Local RSSI, Remote RSSI, Local Noise, Remote Noise)</li><li>Automatic antenna diversity switching on a packet basis in realtime</li><li>Automatic duty cycle throttling based on radio temperature to avoid overheating&nbsp;</li></ul><p></p>

This is a preview of the recently viewed products by the user.
Once the user has seen at least one product this snippet will be visible.

Recently viewed Products

To install this Web App in your iPhone/iPad press and then Add to Home Screen.