<p>The Nano-Nano board was designed to allow you to mount your Team BlackSheep Unify Pro Nano VTX in your stack for cleaner builds. &nbsp;This board includes holes that are compatible with (but not limited to) most receivers such as the FrSky XM+ and Team BlackSheep Crossfire Nano. &nbsp;Once the VTX is soldered into the cutout on the board, the breakout pads on the side allow for full access to your VTX. &nbsp;</p><p><br></p><p>If your camera uses 5V for power, you can solder your pigtail to the camera pads and allow the board to act as a pass through. &nbsp;After your VTX, camera, and receiver is installed, the 5V pad on the board will power all your components.</p><p><br></p><p>There are also two pads located on the side of the board to solder the button that's included with your Unify Nano. &nbsp;The button can be soldered top facing, side facing, or with wires to allow for access to the VTX from anywhere. &nbsp;</p><p><br></p><p>Note: If your receiver requires 3V, you will need to pull power from somewhere else. &nbsp;Do not solder in the 5V header if your receiver is not compatible. &nbsp;You can use the other plated through holes (1, 2, and ground) for your receiver still.</p><p><br></p><h4><b>FEATURES</b></h4><p><br></p><ul><li><p>TBS Unify Pro Nano Video Transmitter support</p></li></ul><ul><li><p>4 plated through holes for mounting receivers</p></li></ul><ul><li><p>Pads for camera pigtail</p></li></ul><ul><li><p>Top or side pads for VTX button</p></li></ul><ul><li><p>20mm x 20mm hole pattern</p></li></ul><ul><li><p>27mm x 26mm dimensions</p></li></ul>