The Cube, Kore is a new Carrier Board of ProfiCNC/HEX. The Cube, Kore integrates all the interfaces of the Standard Carrier Boards and is for use with the Pixhawk2.1 Cube, and future versions of the Cubes provided.

The construction of a Multicopter, and, of course, other vehicle types, to be facilitated by the use of the Cube Kore Carrier Boards is enormous. The integrated Power Distribution Board (power distribution) is already equipped with a current Sensor and a total of 50V and a max. approx. 140 a load.

Built-in Step-Down Module for 5V and 12V consumers (e.g., Gimbal, FPV Equipment and more, additional Payload) to simplify the wiring and reduce overall cable clutter.

In addition, each of the 4 welding pads for the ESC power supply, and pin strips for the Signal cables of the ESC's. The manufacturer has thought in these areas also on a 12V supply for the LED.

Features:

•  Up to 12-cell Lithium battery (50,4 V)
  
• Can withstand up to 140A continuous current short-time load peaks of up to 280A
• Connections for the power supply and the RC Signal for ESCs in the corners
• 12V navigation light power at each corner available, built-in power distribution
• Built-in Sensor for voltage (V) and amperage (A)
• Redundant Layout for flight critical components
• Load plug - in connector with resettable Fuses for 5V, 12V and direct battery supply
• LED indication for power OK or is a Problem/error
• Built-in Buzzer with volume control
• Connectors for each function of the Pixhawk2.1 The Cube
• Easily accessible PWM voltage selection switch (3.3 V or 5 V)
• Resistance to mass Bouncing to the PWM Signal
• Connector compatible with Standard ProfiCNC Carrier Board
• Connector Ports for debugging IO, and FMU