PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification

Input voltage: 2S- 14S

PCB Cont. Current Rating: 70A

PCB Burst Current Rating: 120A (<60 Sec)

Max current sensing: 327A

Voltage and current monitor with I2C compatible interface 

Connector Outputs: 5.2V and 3A max