The HUBOSD8-SE has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB. It is a multifunctional HUB with PDB, BEC 5V/1.5A &10V/1.5A, Current sensor 184A, STOSD8-SE. It is specially made for the mini FPV Quad. The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8-SE can support Plug & Play, no complicated settings needed.

General

Input voltage range (3S-6S operation): 9 - 27VDC

PDB: 4x30A (Max.4x46A)

Regulated 5V and 10V outputs

Current Sensor 184A

Built-in STOSD8-SE

Physical:

- 2oz copper, 4-layers &1.6mm PCB.

- 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 12V outputs.

- Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads

- 1x Serial port (RX, TX, G)

- Dimensions: 46x36x4mm, Weight: 9g

- Mounting holes 30.5mm square spacing，Φ3mm

PDB (ESC outputs)

Continuous current: 30A per output

Peak current (10 seconds/minute): 46A per output

BEC 5V outputs

Designed for RC Receivers, Flight controllers, OSD, and Servos.

DC/DC synchronous buck regulator.

Voltage: 5.0 +/- 0.1VDC

Continuous current: 2 Amps (Max.2.5A 10s/minute)

Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)

Short-circuit tolerant (5 seconds/minute)

BEC 12V outputs

Linear regulator, very low noise. LC Filter is needless.

Designed for Video TX or FPV camera.

Voltage: 12.0 +/- 0.3VDC (4~5S operation)

Continuous current: 1.5A@16V IN

Short-circuit tolerant (2 seconds/minute)

If the battery is 3S LiPo, Output voltage=3S LiPo voltage - 1V

Current Sensor

184A

If current >184A. STOSD display 184A

More info OSD:

http://www.stosd.com/