FC Specifications

• MCU: STM32F405RGT6, 168 MHz, 1MB flash
• IMU: ICM42688-P
• Baro: DPS310
• OSD: AT7456E
• Blackbox: MicroSD card slot
• 6x UART, 1x Softserial_Tx option (INAV)
• 10x PWM outputs
• 2x I2C
• 3x ADC (VBAT, Current, RSSI)
• Built-in inverter for SBUS input
• USB Type C (USB2.0)

FC Firmware

• ArduPilot: MatekF405-Wing (ArduPlane 4.4 or later)
• INAV: MATEKF405SE (INAV 6.0 or later)

PDB

• Input voltage range: 9~30V (3~6S LiPo) with TVS protection
• Current sensor: 220A, 3.3V ADC (scale INAV 150, ArduPilot 66.7A/V)
• Shunt resistor: 100A continuous, 220A peak
• Battery voltage divider 1K:10K (scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)

5V BEC output

• Designed for flight controller, receiver, OSD, camera, buzzer, 2812 LED strip, buzzer, GPS module, AirSpeed
• Continuous current: 2 amps

9V/12V BEC output

• Designed for video transmitter, camera, gimbal, etc.
• Continuous current: 2 amps
• 12V option with jumper pad
• for a stable 9V/12V output, input voltage must be > output voltage +1V

Vx BEC output

• Designed for servos
• Adjustable voltage, options of 5V default, 6V or 7.2V
• Continuous current: 5 amps, 6A peak
• for a stable Vx output, the input voltage must be > Vx voltage +1V

3.3V BEC Output

• Designed for external 3.3V peripherals
• Linear regulator
• Continuous current: 200 mA

Physical

• Mounting: 30.5 x 30.5 mm, Φ4 mm with Φ3 mm grommets
• Dimensions: 54 x 36 x 13 mm
• Weight: 25g

1x F405-Wing-V2

1x 20cm JST-GH-4P to JST-GH-4P cable for I2C port

Dupont 2.54 pins  (The board comes unsoldered)